Tandy Professional Forum   Section: Tandy 2000
Subject: Floppy drive   Total messages: 2
=========================================

#62372   1 Reply   08/21/96   21:22:16
From: Steve E. Hamler, 105015,2622
To:   sysop

Hello

     I hope I'm sending this message the right way.  I have a
technical question for you.  A friend of mine gave me an old
tandy 2500sx/20 computer.  It works well however when I list a
directory on the floppy drive it gives it to me. but if I change
the disk and list a directory,  it gives me the listing for the
first disk I put in.


#62373   Reply to #62372   08/22/96   01:21:08
From: Horace Ory, 71625,1006
To:   Steve E. Hamler, 105015,2622

I don't know anything about that computer.  It sounds like the
change disk signal is not being read.  That might be a poor
contact (loose or dirty) on one of the lines.  As a workaround,
if memory serves me correctly, pressing a Ctl-C before listing
the directory will cause the new directory to be read.


