This text file explains how to install the ODI server driver on this 
diskette into a Netware 3.11 server.  Since the Netware installation program
does not have driver import capability, the starting point for this process 
is assumed to be after the Netware server software is already installed, but 
not running yet.  To install this server driver into a Netware 3.11 server, 
either use the INSTALL program on this diskette or manually copy the files 
to the server's hard disk.  To manually install the driver, do the following 
steps:

First, copy the 3C59X.LAN server driver file from the \NETWARE\SERVER
subdirectory on this EtherDisk to the server hard disk.

Next, copy *.NLM files from the \NETWARE\SERVER\3.11 subdirectory to same
place the server driver was copied.  Failure to copy and use these five NLM 
files instead of the NLM files that came with the 3.11 version of Netware 
may result in network failure or server abends.

Now boot the server, enter the installer, and edit the AUTOEXEC.NCF file
to add the following line (assuming the server start directory is C:\SERVER,
where the LAN drivers and NLM files were copied):

LOAD C:\SERVER\LSLENH.NLM
LOAD C:\SERVER\3C59X.LAN PORT=<portnumber>

Where <portnumber> is the hexadecimal base address of the PCI adapter.  This
address can be obtained from the configuration and diagnostic program.

This LAN driver can only be used in a server that's started from DOS due to
the limited support of the PCI bus by the Netware server.

%VER - Netware 3.11 Server installation release notes V4.2
