TechSpeed Ugrade Drivers
------------------------

There are 3 drivers provided on this disk and each of a
different purpose.

   SPD31.EXE   - the normal version of the driver which should
                 be placed as a device at the beginning of your 
                 CONFIG.SYS file or run from DOS.

   SPD31S.SYS  - this version of the driver should only be used 
                 to help determine if you are having a problem
                 with the normal driver.  It is slower and less
                 functional than the SPD31.EXE driver.

   SPDALRM.TSR - a driver to slow down the alarms played by the 
                 appointment application, which needs to be 
                 placed in the C:\_DAT directory.  Make sure
                 you are on C: drive in your AUTOEXEC.BAT file
                 before 200 runs or it won't load this TSR from
                 the C:\_DAT directory.
                 


Warnings
--------

The vendor takes no responsibility for the results of any 
modifications performed using this kit.  The implementation
of this kit will void your HP warranty.

After you perform the upgrade you can no longer use the TURBO
software to speed up your 100/200LX.  This is due to the fact
that these programs reconfigure some of the internal timings of 
the palmtop.  This will conflict with any timing changes 
performed by the SPD31.EXE driver.

Attention ACE(tm) DoubleFlash+ RAM card users, before using 
your DoubleFlash+ RAM card you will need to take out the 
ACECARD.COM driver from your CONFIG.SYS.  If a CONFIG.SYS 
resides on the RAM card as well, you will need to change that 
one also.  If you do not remove the ACECARD.COM driver, you 
will not be able to access your RAM card!  ACE now offers 
a version of the ACECARD.COM driver, which can be obtained
from their technical support for a small fee.
