Linux version 2.6.29 (aliosa27@the-oracle) (gcc version 4.3.3 (GCC) ) #1 Sat Sep 12 13:15:44 CDT 2009
CPU: XScale-PXA270 [69054117] revision 7 (ARMv5TE), cr=0000397f
CPU: VIVT data cache, VIVT instruction cache
Machine: Zipit Z2
Memory policy: ECC disabled, Data cache writeback
On node 0 totalpages: 8192
free_area_init_node: node 0, pgdat c035e7ac, node_mem_map c0397000
  Normal zone: 64 pages used for memmap
  Normal zone: 0 pages reserved
  Normal zone: 8128 pages, LIFO batch:0
Run Mode clock: 208.00MHz (*16)
Turbo Mode clock: 312.00MHz (*1.5, active)
Memory clock: 104.00MHz (/2)
System bus clock: 104.00MHz 
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
Kernel command line: console=ttyS2,115200 root=/dev/mmcblk0p1 rootdelay=2 fbcon=rotate:3 debug 
PID hash table entries: 128 (order: 7, 512 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 28808KB available (3108K code, 351K data, 176K init)
Calibrating delay loop... 311.29 BogoMIPS (lpj=1556480)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 300 bytes
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
I2C: i2c-0: PXA I2C adapter
Switched to high resolution mode on CPU 0
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
PXA CPU 27x max frequency not defined (pxa27x_maxfreq), assuming pxa271 with 416000kHz maxfreq
PXA CPU frequency change support initialized
audit: initializing netlink socket (disabled)
type=2000 audit(0.330:1): initialized
VFS: Disk quotas dquot_6.5.2
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
pxa2xx-fb pxa2xx-fb: machine LCCR3 setting contains illegal bits: 04300000
pxa2xx-fb pxa2xx-fb: Double Pixel Data (DPD) mode is only valid in passive mono single panel mode
Console: switching to colour frame buffer device 40x30
pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART
pxa2xx-uart.1: ttyS1 at MMIO 0x40200000 (irq = 21) is a BTUART
pxa2xx-uart.2: ttyS2 at MMIO 0x40700000 (irq = 20) is a STUART
console [ttyS2] enabled
brd: module loaded
Probing processor-flash at physical address 0x00000000 (16-bit bankwidth)
processor-flash: Found 1 x16 devices at 0x0 in 16-bit bank
processor-flash: Found an alias at 0x800000 for the chip at 0x0
processor-flash: Found an alias at 0x1000000 for the chip at 0x0
processor-flash: Found an alias at 0x1800000 for the chip at 0x0
processor-flash: Found an alias at 0x2000000 for the chip at 0x0
processor-flash: Found an alias at 0x2800000 for the chip at 0x0
processor-flash: Found an alias at 0x3000000 for the chip at 0x0
processor-flash: Found an alias at 0x3800000 for the chip at 0x0
 Intel/Sharp Extended Query Table at 0x0039
 Intel/Sharp Extended Query Table at 0x0039
 Intel/Sharp Extended Query Table at 0x0039
 Intel/Sharp Extended Query Table at 0x0039
 Intel/Sharp Extended Query Table at 0x0039
Using auto-unlock on power-up/resume
cfi_cmdset_0001: Erase suspend on write enabled
erase region 0: offset=0x0,size=0x2000,blocks=8
erase region 1: offset=0x10000,size=0x10000,blocks=127
processor-flash: 1 set(s) of 1 interleaved chips --> 16 partitions of 512 KiB
RedBoot partition parsing not available
cmdlinepart partition parsing not available
Creating 3 MTD partitions on "processor-flash":
0x000000000000-0x000000010000 : "Bootloader"
0x000000010000-0x000000240000 : "Kernel"
0x000000240000-0x000000800000 : "Filesystem"
spi spi1.0: in setup: DMA burst size reduced to match bits_per_word
mice: PS/2 mouse device common for all mice
input: pxa27x-keypad as /devices/platform/pxa27x-keypad/input/input0
input: gpio-keys as /devices/platform/gpio-keys.0/input/input1
pxa-rtc pxa-rtc: rtc core: registered pxa-rtc as rtc0
i2c /dev entries driver
APM Battery Driver
SA1100/PXA2xx Watchdog Timer: timer margin 60 sec
z2_mci_setpower: on
z2_mci_setpower: on
Registered led device: z2:green:mmc
Registered led device: z2:green:charge
TCP cubic registered
NET: Registered protocol family 17
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
XScale iWMMXt coprocessor detected.
pxa-rtc pxa-rtc: setting system clock to 2000-01-01 00:00:04 UTC (946684804)
Waiting 2sec before mounting root device...
mmc0: SCR structure version 0
mmc0: host does not support reading read-only switch. assuming write-enable.
mmc0: new SD card at address e624
mmcblk0: mmc0:e624 SU01G 968 MiB 
 mmcblk0: p1 p2
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
VFS: Mounted root (ext2 filesystem) on device 179:1.
Freeing init memory: 176K
pxa27x_udc: version 2008-04-18
lib80211: common routines for IEEE802.11 drivers
lib80211_crypt: registered algorithm 'NULL'
libertas_spi: Libertas SPI driver
In z2 SPI setup
libertas: Can't read bus mode register.
libertas_spi: probe of spi1.0 failed with error -5
libertas_spi: Libertas SPI driver
In z2 SPI setup
libertas_spi spi1.0: firmware: requesting libertas/gspi8686_hlp.bin
libertas_spi spi1.0: firmware: requesting libertas/gspi8686.bin
libertas: 00:50:43:02:fe:01, fw 9.70.3p37, cap 0x0000030b
eth0 (libertas_spi): not using net_device_ops yet
udev: renamed network interface eth0 to eth1
libertas: PREP_CMD: command 0x00a3 failed: 2
libertas: PREP_CMD: command 0x00a3 failed: 2
libertas: eth1: Marvell WLAN 802.11 adapter
